Compliance Apps

USB 2.0 and USB 3.0 Compliance Test

Revision 1.0, December, 2009


Using the USB Compliance Test M1 Waveform Tools provides you with an expert solution to your compliance testing needs. M1 Waveform Tools is compatible with every real-time Keysight/Agilent, Tektronix, LeCroy, Rohde & Schwarz, and Yokogawa scope on the market, including the new Keysight/Agilent 90000 and Tek 70000 series. In addition, M1 supports digitizers manufactured by Keysight/Agilent/Acqiris, GaGe,  National Instruments, Spectrum, and ZTEC.

By going with the M1 solution, if you don't meet your numbers you have the full power of M1 available to figure out what the problem is. If you need help, you can collaborate instantly by packaging up your waveform and sending it to your local signal integrity guru.

Most major signal standards are included, for free, with every installation of M1. Regardless of what standard you are working with, you will be ready to begin testing immediately with M1.


Spec Level:      USB 2.0, USB 3.0

App Update Level/Date:      1.0, December 2009

Best Practices Revision Level:      4

Minimum M1 version required:      v4.00

App Encryption:      none

Measurements Made:     

  • Table 7-2. Low-/full-speed Signaling Levels
  • Table 7-3. High-speed Signaling Levels
  • Table 7-7. DC Electrical Characteristics
  • Table 7-8. High-speed Source Electrical Characteristics
  • Table 7-9. Full-speed Source Electrical Characteristics
  • Table 7-10. Low-speed Source Electrical Characteristics


  • Testing will require 2 x single-ended probes


  • Not Applicable for this App



Provide This email address is being protected from spambots. You need JavaScript enabled to view it. to ASA about this App